HYDRAULIC FLY SHEAR FHS-600-2000

HYDRAULIC FLY SHEAR FHS-600-2000

HYDRAULIC FLY SHEAR FHS-600-2000

 Fly Shear used i the  cut to length coil lines to have constant speed and precision planarity for thickness up to 12 mm

In the CTL coil line it is very important to have perfect planarity so the Leveler has to run constant speed (not start/stop) to obtain perfect planarity, so the Band has to run continuosly at the same programmed speed, and the Shear has to follow the band up to the programmed feed length, than cut, after cutting the SFly Shear return back to follow the next target

Some time it is also necessary to have inclinated cut, to make Trapezoidal format, in this case the Shear has also to SWING +- 30 - 45 ° in this case need another rotating support at the bottom with other Servo Motor, we also did a lot of them

We use the standard frame of the Hydraulic Shear mounted in the appropriate slide with linear gear and Servomotor

The question it is quite special for the request we have to consider a lot of parameter but also fot this case we are specialist.

For any special question do not be afraid to contact us

 

Cookies help us in providing our services. By using our services you agree that we set cookies. Read more.